Adafruit DRV8871 DC Motor Driver Breakout Board - 3.6A Max

Key Features: Super simple to use Works with just about any brushed DC motor. You can set the current limiting with an removable external resistor Rlim Crank up your robotics with powerful Adafruit DRV8871 motor driver breakout board. This motor driver has a lot of great specs that make it useful for a wide variety of mechatronics. In particular, the simple resistor-set current limiting and auto-magic PWM support make it super easy to use with just about any brushed DC motor.Using it is super simple. Connect your motor to the OUT terminal block. Power the board with 6.5-45VDC power on VMotor and provide the H-bridge input control on IN1 and IN2. You can even PWM the inputs and the driver chip will do the right thing.You can set the current limiting with an external resistor Rlim. We solder in a 30K resistor by default for a ~2A current limit, however you can remove this resistor and/or solder a resistor over it to change the resistance and change the limit.Item Specifics1 - Fully assembled and tested motor driver breakout2 - 2-pin terminal blocks (blue or black)1 - small strip of header6.5V to 45V motor power voltageUp to 5.5V logic level on IN pins565mΩ Typical RDS(on) (high + low)3.6A peak currentPWM controlCurrent limiting/regulation without an inline sense resistorUndervoltage lockoutOvercurrent protectionThermal shutdownSize: 24.4mm x 20.4mm x 9.7mm / 1.0" x 0.8" x 0.4"Weight: 2.2g / 0.1ozSome light soldering is required to attach the header and terminal blocks