SKINNY Metal can holder 15oz Sublimation ready blanks RTS, skinny can cooler metal, 2 lids, 2 in 1 skinny metal can coolers

Product Name Skinny Metal Can Holder for Sublimation Product Details Color: White Type: Insulating metal can holder Compatibility: Holds tall, 15 oz skinny cans, 12 oz regular cans, and bottles Can be used as a regular tumbler with additional screw-on lid (included) Includes screw on top for holding skinny cans and plastic straw (rubber bottom sold separately if desired) Features: Shiny white sublimation coating for vibrant colors Suitable for use in a mug press or convection oven Convection oven use requires shrink wrap for pressure (sold separately) Accessories (sold separately): Shrink wrap for convection oven use Rubber bottoms (sold separately) Convection Oven Directions Apply sublimation transfer on the surface of the tumbler using heat tape. For full wrap designs, make sure you pull the transfer as tightly as possible around the tumbler, then tape very well along the seam and around the top/bottom of the tumbler. Pulling the tape/transfer as tight as possible with no air pockets. If your transfer does not fully cover the tumbler surface, apply blowout/butcher paper to the entire tumbler so that there is no metal showing on the sides.  Apply shrink wrap using a heat gun to shrink it tight to the tumbler.  Bake in a convection oven at approximately 385-400 degrees F for 5-6 minutes, turning halfway. If your tumbler is touching a metal surface during baking, the shrink wrap will be more likely to melt! Remove from oven and immediately remove shrink wrap and transfer. TUMBLER WILL BE HOT!! No sealant is necessary on sublimation tumblers. Care Instructions: Hand wash recommended; dishwasher heat may cause bleeding PLEASE NOTE: Equipment varies and so may your required settings. Please test your equipment using these baseline recommendations. Additional Information For more information on sublimating these, please visit ACC Sublimation Blanks & Designs Facebook group for videos.