
Proto Shield for Arduino with Mountable Breadboard
Product Contents 1 piece - Proto shield board for Arduino 2 piece - 1x6 male header pins 2 piece - 1x8 male header pins 2 piece - 1x5 female header 2 piece - 1x6 female header 2 piece - 1x8 female header 1 piece - White 170 tie point breadboard with adhesive foam backing and release paper Specifications Breadboard has adhesive backing and can be applied to the proto shield or used separately 0.1”x0.1” spaced prototyping grid 2 SMD LEDs in red with corresponding resistors mounted on top of shield; LEDs wired to ground, but a positive voltage needs to be connected to each LED's corresponding positive pad 2 buttons, including 1 reset button and 1 general purpose button; general purpose button is hard-wired to ground (GND) and its other connection is brought out to a pad 5-hole general purpose rail on PCB that is not connected to anything else on the shield that can be used at will Two 5-pin female headers: 5V and ground (GND) Four 12-hole power rails on PCB: two 5V and two GND (along middle and edges of prototyping area) Gold-plated pads Each pin from a connected Arduino is brought out to header pins on this shield (Compatible with UNO R3 but does not bring up the IOREF pin from the attached UNO R3) Can add DIP ICs up to 20 pins to middle of prototyping area Includes an area for surface-mount chips; can fit up to size SOIC 14 parts