SPEEDYBEE STACK F7 V2

FC SPEC MCU: STM32F722 IMU: MPU6000 USB: Type-C Baro: BMP280 (I2C) OSD: BetaFlight OSD w/ AT7456E chip BLE: Support, used for Flight Controller configuration WiFi: Support, used for data transfer, e.g firmware flashing, and Blackbox analysis. DJI Air Unit slot: A full DJI Air Unit JST slot onboard BlackBox: 16MB onboard dataflash Current Sensor: 1 : 10 (Scale 168) BetaFlight Camera Control Pad: Yes Power input: 3S - 6S Lipo 5V power output: 7 * 5V output, 6 pads and a BZ+ pad used for Buzzer, the maximum load current is 2.5A. 9V * 1, the maximum load current is 2.5A. 9V power output: 2 * 9V output, 1 pads and another one used for DJI slot 4.5V power output: 1 * 4.5V output pad 3.3V power output: 1 * 3.3V output pad, the maximum load current is 500mA. ESC signal: M1 - M4 UART: Full UART * 5(UART1, UART2, UART3, UART5, UART6) ESC Telemetry UART: UART4 RX I2C: Used for external Magnetometer, Sonar, etc. LED pin: Used for WS2812 LED Buzzer: BZ+ and BZ- pad used for 5V Buzzer Boot button: Used to easy enter DFU mode RSSI input: RSSI input solder pad SmartPort: Use any TX pad of UART for the SmartPort feature. Support Flight Controller Firmware: BetaFlight(Default), EMUFlight Target name: SPEEDYBEEF7V2 Mounting: 30.5 x 30.5mm,  4mm hole size Dimension: 41 x 38 x 6.9mm Weight: 9g ESC SPEC Firmware: BLHeli32 SpeedyBee 4in1 MCU: STM32F051 Continuous Current: 45A * 4 Burst Current: 55A(10S) ESC Protocol: DSHOT300/600/1200 Power input: 3S - 6S LiPo Power output: VBAT Current Sensor: Support (Scale 168) ESC Telemetry: Support Mounting: 30.5 x 30.5mm, 4mm hole size Dimension: 41 * 45 * 6.5mm Weight: 12.5g INCLUDES 1x SpeedyBee F7 V2 FC 1x SpeedyBee 45A ESC 1x 50V 470uF Capacitor 1x XT60 Cable 1x JST 8pin 30mm 1x JST 8pin 15mm 1x DJI 6pin 80mm 5x M3*30 screws 5x Nylon Nuts 5x Grommets M3*8mm 5x Grommets M3*6.6mm