EVOLink EVO8X

Easy to install. Affordable. Reliable.  G4X PlugIn ECUs offer the latest in engine management technology, designed to easily maximize the potential from your car.  This ECU fits inside the factory OEM enclosure. Installation is a breeze, with no alteration of the factory wiring loom required for the models listed below. This ECU is designed for the EVO 4-8 4G63 engine.  Please check your connector matches the header in the listed photo before purchasing.   This ECU works for manual transmissions only.   Includes onboard 4 bar or 7 bar MAP sensor  Most factory features are supported.  Check the features tab for I/O expansion options  Suitable applications:  CN9A Lancer Evolution 4 CP9A Lancer Evolution 5, 6 & 6.5 (TME) CT9A Lancer Evolution 7 CT9A Lancer Evolution 8 (models with 4-plug ECU only) *Some EVO 8’s have a 3 plug ECU. These applications will need the EVO9X Link ECU G4X PlugIn Key Features (where applicable):Up to 6D fuel and ignition mappingPrecision closed loop cam control (four cam, independent control)Sequential fuel deliveryDigital triggering, all OEM patternsOEM idle hardware supported5D boost control with three switchable tablesMotorsport features - antilag, launch, flat shiftContinuous barometric correction (on board)CAN portQuickTune - automated fuel tuningIndividual cylinder correctionUSB tuning cable includedStats recording into on-board memoryGear compensations for spark, boost and fuelReal time selectable dual fuel, ignition and boost mapsSync and crank sensors can be a combination of Hall effect, variable reluctance or opticalBoost control referenced to gear, speed or throttle position512 mega bytes data logging memoryStaged injectionKnock with "windowing"I/O Expansion OptionsThe following expansion connector inputs/outputs are provided: The Mitsubishi Lancer Evolution IV - VIII plug-in ECU has two expansion connectors. Expansion connector 1:Gnd                Sensor Ground Only  +5V Out        Low Current +5V Supply DI 7                Digital input DI 8                Digital input DI 9                Digital input Aux 4                Auxiliary Output Ign 7                Ignition 7 Auxiliary Output Ign 8                Ignition 8 Auxiliary Output Expansion Connector 2 Gnd                Sensor Ground Only  +5V Out        Low Current +5V Supply Aux 9                EThrottle - can't be used as an Aux Out Aux 10                Auxiliary Output An Volt 6        Analog 0-5V input An Volt 7        Analog 0-5V input An Volt 9        Analog 0-5V input An Volt 10        Analog 0-5V input Download Manual Click here Click here to download the full Specifications PDF.