Tail Light Turn/Reverse Signal Pre-Cut Overlay Smoked for 2024+ Sonata

2024+ Sonata Tail Light Turn / Reverse Signal (Smoke or Light Smoke) Elevate your ride with our 2024+ Sonata Tail Light Turn/Reverse Signal Pre-Cut Overlay Smoked! Say goodbye to random clear bulbs with our smoked or light smoked options. Achieve a sleek and bold finish that will make heads turn on the road. Upgrade your style now! Specification: Fitment : [ 2024+ Sonata ] Rear Tail Light Turn / Reverse Signal of the 2024+ Sonata High-Quality durable material. 5-year durability  Smoked and light smoked - an Ultra-gloss nano-air tint material Comes in pairs ( Passenger side and Driver side Tail Light Turn / Reverse Signal) Easy to apply and install. Perfect fitment guaranteed. Available in LIGHT SMOKE, DARK SMOKE NOTE  Not an actual replacement, this is an overlay tint that is applied onto the existing tail light. How to Install For Best Results Tools: Heat Gun or Blow Dyer / Padded Glove or Felt Tip Squeegee Rinse / Soap the entire Tail Light reverse/turn signal to remove all debris and dust. Peel the overlay off the backing paper. Remove the turn signal overlay first and align the curve of the top left if working on the driver-side tail light and the rest should fall into place. Ensure the overlay meets at the bottom where the clear and black portions are. Smooth out the overlay and push any bubbles to the closest edge. Next, peel the reverse signal overlay and lay it at the edge where the trunk opens up. Lay it with the pointed edge at the top closest to the black part of the tail light (just below the red long brake light) Once laid, it should lay at the bottom of the clear and very or on the black part of the tail light. It should cover the reverse and end at the groove where the reverse light ends. A padded card is not required, your fingers will work fine on laying the overlay on top of the reflector. Swipe your finger towards the end of the overlay as you lay it down or move up and down while laying the overlay to improve adhesion and get rid of bubbles in the process. If you have a blow dryer or heat gun, use it to get rid of any tiny bubbles and improve adhesion If there are bubbles make sure you press firmly with your finger and swipe it toward the closest edge If you mess up, you can peel it off right away with no hassle, and add some heat to get rid of the wrinkles. After fully laying the overlay, heat up the overlay to ensure no lifting and improved adhesion on the smoke/blackout. Peel off the protective layer once done.