Rear Bumper Reverse Light Pre-Cut Overlay for 2024+ Ford Mustang

Rear Bumper Reverse Light Reflector Pre-Cut Overlay for 2024+ Ford Mustang Transform the rear of your 2024+ Ford Mustang by using our Rear Bumper Reverse Pre-Cut Overlay. Add a pop of color to your reverse light by removing the clear. Available in dark smoke, light smoke, JDM Yellow, Blue Smoke, and Cherry Red. This upgrade will inject a bold touch and elevate the overall appearance of the rear. Customize your rear to be one-of-a-kind and fierce with a straightforward stick-on addition! Fitment: For 2024+ Ford Mustang Rear Bumper Reverse Light High-Quality Material: Can withstand all kinds of weather (5 - 7 Year Durability) Smoked and Color Tint Vinyl Sticker, Changes the Rear End of your Vehicle Easy Application ** NOTE ** Not Actual Reverse Light Replacement: This product overlays the existing Reverse Light with Tint.  How to Install Rear Bumper Reverse Light Pre-Cut Overlay for 2024+ Ford Mustang For Best Results*PROFESSIONAL INSTALL RECOMMENDED, BUT NOT REQUIRED*Tools: Heat Gun or Blow Dyer / Padded Glove or Felt Tip Squeegee Rinse / Soap your Reverse light to get rid of debris prior to application. Peel off the Reverse light Tint Overlay. Align the Overlay at any pointed edge on the left or right side. Once aligned the rest will fall into place, however, it is best to use your free hand to guide the overlay to the other edge and make sure the overlay follows the top line of the reverse light. Make sure you use your free hand to guide the placement and lay down the overlay from top to bottom, from left to right or vice versa. Ensure you have a padded card or soft glove to put on your fingers to begin applying the overlay on the light. If not, your fingers will work If you have a blow dryer or heat gun, use it to get rid of any tiny bubbles and improve adhesion If there are bubbles make sure you press firmly with your finger and swipe it toward the closest edge If you mess up, you can peel it off right away with no hassle, and add some heat to get rid of the wrinkles. Post heat with heat gun or blow dryer for increased stickyness / tackiness to prevent lifting or peeling. NOTE  for Smoke Out, there is a thin plastic liner that needs to be removed after install.