Sipeed SLogic Combo 8 Slogic Analyzer Debugger Tool

Sipeed SLogic Combo 8 Slogic Analyzer DAPLink CKLink Debugger Tool 4 in 1 multifunctional Maximum 8 channels logic analyzer 1. Introduction Sipeed SLogic Combo 8 is a development tool with functions of logic analyzer, CKLink debugger, DAP-Link debugger and USB2UART, which can be switched arbitrarily by buttons. In Windows environment, the Sipeed SLogic Combo 8 has maximum transmission bandwidth of 160 Mb/s. The typical configuration includes 80M@2CH and 40M@4CH. 2.CKLink Function Parameters CKLink SLogic Combo 8 JTAG Clock Rate 16M Typical Dump Speed 1200KB/s Debug Serial Port Up to 20Mbps 2.3. DAPLink Function Parameters DAPLink SLogic Combo 8 Debug Serial Port Up to 20Mbps Typical Burning Speed 110KB/s 2.4. UART Function Parameters High Speed Four Serial Ports SLogic Combo 8 Maximum Baud Rate 2x20Mbps+2x1Mbps Total Bandwidth 42Mbps Sipeed SLogic Combo 8 has four functions (SLogic, CKLink Debugger, DAP-Link Debugger, USB2UART). This document is intended to guide you on how to select the functions. 1. Button Functions After power on, press the button to switch functions, and you can see the indicator light change when the switching is successful. （Up：The red box indicates the position of the function switch button） Note: When switching functions, do not press the button more frequently than every 100ms; otherwise, it may cause the module to enter boot mode, and you will see that the indicator light will no longer change. If you encounter this situation, try to restart the power supply.   2. Indicator Light Color and Functions Each function corresponds to a specific color, and you can determine the currently enabled function based on the indicator light color. Function Slogic DAPLink USB2UART CKLink Indicator Light Color Blue Green Red Yellow （Up：Table of Indicator Light Color and Functions）   3. Panel Information You can check the current function and corresponding wire sequence through the panel information: The left side shows the wire sequence for CKLink (Yellow)and DAPLink (Green) together, as their wire sequences are similar. The middle section shows the wire sequence for UART (Red). The right side shows the wire sequence for SLogic (Blue). （Above：Color/Function/Wire Sequence Correspondence Diagram） Here's an example: If you want to use the SLogic function, press the button to switch the indicator light to blue. This will enable the SLogic function, and you can find the pin wire sequence for SLogic under the blue font on the panel. If you want to use the UART function, press the button to switch the indicator light to red. This will enable the UART function, and you can find the pin wire sequence for UART under the red font on the panel. Alright, now you can switch to the function you need and proceed to the next step! For more information about Sipeed SLogic Combo 8, please contact us.