Primer

Using the 3M Primer 94 for the At The Ready Gun Mount Installing the mount using 3M Primer 94 Prep the vehicle (or other location) where the 3M Primer will be applied, and the gun mount installed, to protect surfaces from any drips that might occur during application. Clean the general area with 50/50 mixture of alcohol and water, make sure surface is dry before continuing. Peel off the red backing from the 3M adhesive tape on the back of the gun mount. Temporarily and lightly locate the gun mount in the correct orientation where you will want it.  Press the mount at this time only enough to allow it to stay where it’s put. Outline the mount onto the surface (dash) with a pencil, then remove the mount and set it down tape side up. Pick up the 3M Primer94 tube, shake vigorously for several seconds, and bend the white cardboard tube until the glass vial encased inside the tube breaks. At this point the applicator will become moistened with the primer solution and will be ready.  Apply a