(C42) 16ch Rack'd Fly Sennheiser EW-DX 16 Channel Ready to Use Wireless System - just 2 antennas in an SKB Rack in a Case

  We specialize in building Easily Transportable Wireless Systems For Theatre or Performance NB: All Rack'D systems are built to order and take 2-3 weeks to complete ready for shipping Our Rack'D FLY CASE 16 channel EW-DX digital audio over UHF system is built around 8x SENNHEISER EW-DX-EM dual channel half width rack receivers (1/2 width 1u rack) and EW-DX-SK transmitter bodypacks plus a high performance antenna distribution .system so that everything can be run from just 2 antennas and built into an SKB 3i-2217M146 Rack in a Rolling Case.   Our systems always cost less than the sum of the parts using Shure products throughout, but provide the same level of performance: Our systems always cost less than the sum of the parts using Shure products throughout, but provide the same level of performance: Our system uses our active Creative Audio CA.D29 dual  9 way(8 way plus cascade out to link to anther rack) antenna  distribution system so the whole system runs on just 2 x 1/2 wave whip antennas. We include 15 bodymics brand Broadway BLF4 lavalier/hairline microphone elements (yep 3 spares, cause we know one will be wrecked at the worst possible time - you can upgrade to other mic types. EQUIVALENT PARTS LIST: OTHER PARTS WE INCLUDE: Internet cost of major components - receivers, transmitters, mics, antenna distros and case is a little over $24,000.00 If you purchased all the items including internal wiring, hardware etc it could cost around $25,700.00, but we are charging just $23,499 ready to use- around $100 less than cost of major items plus the labor to unpack, assemble, test and ship, and then we include the following: tailored length dc and antenna cabling for our TidyRack(TM) look - no more rats nests  assembly - put everything into the rack, cable it and test it  order and gather all the necessary parts  unpack everything  assemble the receivers - add rack ears/joiners unpack the SKB fly rack and prep for use  bolt the receivers into rack mount the active antenna distributor and cable fit Antenna Panel connect the XLR looms to each receiver and anchor to rack  connect power and antenna cables between units  attach channel numbers to each receiver and each transmitter select 16x frequencies that will "play nice" together at your zip code program these frequencies into the receivers sync the transmitters to it's matching receiver  connect the XLR outputs into a test sound system  unpack the 20 microphones, connect each to a transmitter , and test that each microphone, transmitter and receiver works as specifies  repack for shipping  BMRD BMSW BMRDSW BMRDSB R'D-FLY