Lectrosonics DCR822-A1B1 Compact Dual Channel Digital Receiver, 470.100 - 607.950 MHz

Lectrosonics DCR822-A1B1 Compact Dual Channel Digital Receiver, 470.100 - 607.950 MHz The DCR822 compact 2-channel digital receiver with analog and digital audio outputs utilizes the Lectrosonics signature digital architecture with remarkable audio quality and ultra-low latency. The receiver includes an extended operating range rivaling the best analog and Digital Hybrid Wireless® systems with continuously tunable tracking filters covering the entire frequency band of the unit. The innovative Vector Diversity technology raises the bar for digital transmission integrity with two RF front ends per channel, and a unique phase-matching system. The extremely robust RF front ends of the receiver will hold up in severe RF environments and close carrier spacing, whether analog or digital. The DCR822 has a flexible output routing scheme, allowing a variety of applications including Talkback. And, a digital recorder at 24 bits, 48 kHz is included - and records up to 4 audio tracks on a front-mounted microSD card. The 822 receiver is compatible with pure digital transmitters from the D Squared line including the DBSM, DBSMD, DBu, DHu, DPR and DPR-A. The 822 is also compatible with stereo digital transmitters including the DCHT and M2T. Finally, the receiver is also backward compatible with any Digital Hybrid Wireless transmitter made in the last 20 years. Key Features Compatible with D2, Duet and Digital Hybrid Wireless® transmitters Vector Diversity with two receivers per channel for superior digital signal recovery High IP3 and high-current front ends for robust performance even in severe RF environments IR bi-directional port for transmitter setup Analog and Digital audio outputs with TalkBack (in applicable RX modes) USB interface Up to 4 channel recording on microSD card (depending on RX modes) AA Battery or external powering Same cross-section as the UCR411a for mounting using existing hardware Bright, high-density OLED display for clear viewing in any lighting conditions AES 256-bit, CTR mode encryption, with 4 different key policies available Technical Specifications Operating Frequencies (MHz) Model A1/B1 470.100 - 614.375 Frequency Selection Steps 25 kHz Frequency Response 25 Hz to 20 kHz (+0/-3 dB) Frequency Stability ±0.001 % Front end bandwidth ±5.5 MHz, @ -3 dB Sensitivity 20 dB Sinad 0.9 uV(-108 dBm), A weighted 60 dB Quieting 1.12 uV (-105 dBm), A weighted AM rejection >60 dB, 2 uV to 1 Volt Modulation acceptance 85 kHz Spurious rejection 85 dB Third order intercept +15 dBm Diversity method Vector Diversity Antenna inputs Dual SMA female jacks; 50 Ohm impedance Audio output Rear panel 2 TA3M connectors; can drive 600 Ohm, adjustable from -50 to +5 dBu in 1 dB steps (into nominal 10 k bal. load) Input Dynamic Range 125 dB (with full Tx limiting) Overall Latency (time delay) 1.4 ms with digital source, <2.9 ms with Hybrid TX Audio Test Tone 1 KHz, -50 to +5 dBu, <1%THD Controls Front Panel LCD display Menu/Sel, Pwr/Back, Up/Down Arrow Buttons SD Card Reader IR Port Rear Panel Analog/AES audio output jack (2) External DC input Battery compartment USB port External Power Minimum 9 Volts to maximum 17 VDC 2.5 W; 170 mA at 12 VDC Battery Life 6 hrs. continuous, w/ 4 disposable, 1.5VDC AA Lithium batteries (recommended) Weight 408 grams with batteries (14.4 oz.) Dimensions 3.23” wide x 1.23” high x 4.75” deep 82.042 wide x 31.242 high x 120.650 deep mm Recorder Storage media microSDHC memory card File format .wav files (BWF) A/D converter 24-bit Sampling rate 48 kHz Recording modes/Bit rate 24 bit - 144 kbytes/s per channel (up to 4) Frequency response 25Hz to 20 kHz; +0/-3 dB Dynamic range 110 dB (A), before limiting Distortion < 0.035% Operating temperature range Celsius -20 to 50 Fahrenheit -5 to 122 Included Accessories 4x AA Batteries MicroSD card (part# 55010) A1B1 version 2x AMJ-19 and 2x AMJ-22 antennas B1C1 version 2x AMJ-22 and 2x AMJ-25 antennas 941 version 2x AMJ-944 antennas CCMINI zippered pouch