12 oz Standard Can Coozie Sublimation Blank Beverage Holder - WHITE

Double-wall vacuum insulated bottle & can beverage holder Keeps drinks hot/cold all day 18/8 stainless steel (304 food grade) with seamless construction Dimensions: USING A MUG PRESS:Note: Because not all mug presses are created equally the dwell time in apress can vary. The settings below are based on a GKDK3 mug press from GeorgeKnight.2nd Note: Be sure that the artwork does not go beyond the size limits of themug press.3rd Note: Because of the gap where the mug press closes you will not be ableto have the artwork wrap around the entire beverage holder.Supplies needed:- sublimatable substrate (beverage holder)- sublimation transfer- scratch paper- heat tapeMug heat press settings:- temperature - 380 degrees F- dwell time - 1 - 1:15 minutes- pressure - light to mediumSteps:1. Remove the top of the beverage holder2. cut your transfers so that the transfer is slightly larger vertically thanthe beverage holder.3. Position the substrate onto the transfer.4. Tape two ends of the transfer allowing for the gap in the mug press whereit will close.5. Wrap a piece of scratch paper around the transfer and beverage holdertaping if necessary.6. Center the transfer and beverage holder in the mug press.7. Close the mug press using the heat press settings above.8. Remove items from the press immediately. Use heat resistant gloves ifnecessary - the items will be very hot.9. Remove transfer and scratch paper.Tips:- If the image of the final product appears light increase the pressure orthe dwell time slightly (10-15 seconds).- If the image on the final product appears blurred or substrate appearsyellowed or has brown spots on the rim of the top or bottom of the beverageholder reduce the dwell time slightly (10-15 seconds).- Too much pressure can cause trapped moisture in the paper to "jet" awaypulling ink with it in a spiked-peaked formation. To avoid this reduce thepressure.- Take care when applying pressure as too much press can cause the beverageholder to bend slightly which will prevent the lid from fitting properly.IN A CONVECTION OVEN (with Silicone Wrap - MGWRP6):Note: Because not all ovens are created equally the dwell time in an oven canrange from 3:30 to 4:30 minutes. Convection oven is recommended.Settings willvary depending on the oven brand and model ink and paper and atmosphericconditions.2nd Note: Be sure that the artwork does not go beyond the size limits of thewrap.Supplies needed:- sublimatable substrate (polar camel)- sublimation transfer- scratch paper- Silcone Wrap (MGWRP6)- heat tape- convection ovenOven settings:- temperature - 380-400 degrees F- dwell time - 3:30 to 6 minutesSTEPS:1. Position transfer onto the substrate using heat tape to secure the transferto the substrate.2. Cut a piece of scratch paper to tape over your artwork transfer thisprotects your wrap from ink.3. Use the silicone wrap to secure the transfer to the Polar Camel startwrapping the Polar Camel by stretching and rolling the silicone over top ofitself. Make sure to start wrap in a non artwork area to prevent a line inyour artwork.4. Put a piece of heat tape around silicone wrapped Polar Camel to securewrap.5. Place Polar Camel in oven with recommended settings listed above.6. Pull from oven and remove wrap and paper. Caution contents will be hotuse heat resistant gloves for safety.Tips:- If the image of the final product appears light increase the pressure orthe dwell time slightly (30-45 seconds).- If the image on the final product appears blurred or substrate appearsyellowed or has brown spots reduce the dwell time slightly (30-45 seconds).