D & B-Series OBD2 Tucked Engine Harness Kit w/ Subharness | 96-98 Civic EK

Our engine harness is made with new high quality connectors, and automotive grade wiring. Carefully designed to run hidden in the engine bay to enhance the aesthetic "wire-tuck" look. The installation is less complex than our competitors, 95% plug n play.  This harness is made with OBD1 (92-95) ECU Connectors. An ECU adapter can be used for OBD2 ECU's if needed however our harness does not support USDM OBD2 ECU's. Aftermarket ECU's using OBD2 plugs and NON-US OBD2 ECU's are compatible (except H22 and GSR stock units). Each harness will come with a custom sub-harness depending on which chassis you order from our site. If you ever decide to change the chassis you would only require a new sub-harness. The engine harness will drop in to the new chassis without an issue. ***Note: Charge harness not included must be ran independently. Must run High Impedance injectors, is not compatible with a resistor box.This kit includes:1x Wire Tuck Engine Harness1x Sub (Underdash) HarnessInjector Connector: OBD2Alternator Connector: OBD2Distributor: OBD2 10-PIN Connector Label Abbreviations: FAN - Radiator Fan SwitchVSS - Vehicle Speed Sensor (Trans)GND - Chassis GroundDIS -DistributorREV - Reverse LightsECT -Engine Coolant Temp SensorVTS - VTEC SolenoidH2O -Temp sender for Cluster (Coolant)ST -Starter Trigger1 - 4 -InjectorsO2 - Oxygen SensorALT - AlternatorKS - Knock SensorOIL - Low Oil Pressure WarningIAT - Intake Temp. SensorEXTRA - AUX WIRES (Can be pinned for Boost by Gear, etc.)TPS -Throttle Position SensorIAC -Idle Air Control ValveMAP - Manifold Pressure Sensor