Adafruit 0.56" 4-Digit 7-Segment Display w/I2C Backpack - White

Note:  This is the original version of the i2C backpack.  It does not have STEMMA connectors. If you require a different version, please contact us!   What's better than a single LED? Lots of LEDs! A fun way to make a small display is to use an 8x8 matrix or a 4-digit 7-segment display. Matrices like these are 'multiplexed' - so to control all the seven-segment LEDs you need 14 pins. That's a lot of pins, and there are driver chips like the MAX7219 that can control a matrix for you but there's a lot of wiring to set up and they take up a ton of space. Here at Adafruit we feel your pain! After all, wouldn't it be awesome if you could control a matrix without tons of wiring? That's where these adorable LED matrix backpacks come in.  The matrices use a driver chip that does all the heavy lifting for you: They have a built in clock so they multiplex the display. They use constant-current drivers for ultra-bright, consistent color (the images are photographed at the dimmest setting to avoid overloading our camera!), 1/16 step display dimming, all via a simple I2C interface. The backpacks come with address-selection jumpers so you can connect up to four mini 8x8's or eight 7-segments (or a combination, such as four mini 8x8's and four 7-segments, etc) on a single I2C bus. The product kit comes with: A fully tested and assembled LED backpack Ultra-bright 4-digit 0.56" tall white seven-segment display 4-pin header A bit of soldering is required to attach the matrix onto the backpack but its very easy to do and only takes about 5 minutes. Of course, in classic Adafruit fashion, we also have a detailed tutorial showing you how to solder, wire and control the display. We even wrote a very nice library for the backpacks so you can get running in under half an hour, displaying images on the matrix or numbers on the 7-segment. If you've been eyeing matrix displays but hesitated because of the complexity, his is the solution you've been looking for!   TECHNICAL DETAILS   This board/chip uses I2C 7-bit address between 0x70-0x77, selectable with jumpers Backpack Dimensions: 27mm x 50mm x 4mm / 1.1" x 2" x 0.16" Backpack Weight: 5.3g 7-Segment Display Dimensions: 19mm x 50mm x 14mm / 0.75" x 2" x 0.56" 7-Segment Display Weight: 8.4g Datasheets, schematic, EagleCAD PCB files, and Fritzing available in the product tutorial