Holybro Kakute F7 HDV AIO - Tekko32 F3 Metal 65A ESC Combo
Holybro Kakute F7 HDV All-In-One is designed to work with the DJI FPV VTx module. The GH port available on the board makes it much more convenient for you to connect Holybro Kakute F7 HDV AIO to the DJI FPV VTx, for both signal and power supply. New BLHELI32 ESC with F3 MCU, give more smooth control and faster responding speed. Supports up to 80A burst and 65A continuous. (ESC mounted under props, without anything covering the ESC) Kakute F7 HDV AIO: Features: High-performance / low-noise IMU. MPU6000 with 6-axis gyro and accelerometer. Ready for autonomous flight: Integrated BMP280 barometer and SCL/SDA for use with external GPS/magnetometer units. Dedicated bootloader button for easy firmware flashing. Low-profile design fits into even very compact frames. 2 oz. copper PCB allows up to 120A maximum continuous current. Input voltage 7v to 42v. Power the board directly from the flight pack, up to 6S (on “B+” pad only). Automatic voltage monitoring. No need to run a separate vBat wire for voltage monitoring; the KAKUTE F7 HDV AIO monitors voltage directly from the power supply. Filtered voltage output for clean, noise-free video. 2 On-board regulators output 5V and 8V. 5V output up to 1.5A to power peripherals such as receiver, FPV camera, or LED strip. 8V output up to 2A to DJI FPV VTx. Supports BLHeli pass-through for easy ESC upgrade and configuration. Specifications: MCU: STM32F745 32-bit processor IMU:MPU6000 Barometer: BMP280 USB VCP Driver (all UARTs usable simultaneously; USB does not take up a UART) 6 hardware UARTS (UART1,2,3,4,6,7) All UARTS support hardware inversion. SBUS, SmartPort, and other inverted protocols work on any UART without “uninvert hack”. Supports serial receivers (SBUS, iBus, Spektrum, Crossfire) only. PPM and PWM receivers are not supported. TF card for Blackbox logging Dimensions: 45x37mm Mounting Holes: Standard 30.5mm square to center of holes Weight: 10g Tekko32 F3 Metal 65A ESC Combo: Features: Small size/low weight Built-in Current sensor Voltage output (VBAT), ESC Telemetry(TELEM) Supports Oneshot / Multishot / Dshot 32bit ESC with BLHELI32 firmware On-Board RGB LED (WS2812B LED) Auto Timing Feature Smooth Response Specifications: F3(M4 Core) MCU, Runs BLHELI32 firmware, the MCU works at 108Mhz Mosfet tested at 4S 65A, under props, nothing covered for 1min 18 x 27 mm Supports Lipo 3-6S Ext. cap needed for 6s (220uf 35v for 6s usage.) Onboard WS2812B LED Weight: 4.4g (1pcs) Includes:1x Holybro Kakute F7 HDV AIO Flight Controller4x M3 Damping Balls1x JST GHR 8pin to JST GHR 6pin 80mm cable4x Holybro Tekko32 F3 Metal 65A ESCs4x ESC Wire Sets4x Electrolytic Capacitors 220uF 35V Kakute F7 HDV AIO Manual