Intel I210T1BLK Single Port PCI-Express x1 Ethernet Server Adapter
Specifications Mfr Part Number: I210T1BLK General Features: Intel Ethernet Controller I210 w/ PCI Express v2.1 Support Low Halogen Low profile single-port copper adapter Ship with full-height bracket installed; low-profile bracket included in package, Single-scew mount Ventilated bracket Ethernet Features: Audio-Video Bridging (AVB) Support (802.1 Qav) IEEE 802.3 auto-negotiaton 1 Gb/s Ethernet IEEE 802.3, 802.3u, 802.3ab PHY specifications compliant Integrated PHY for 10/ 100/ 1000 Mb/s for multi-speed, full, and half-duplex IEEE 802.3x and IEEE 802.3z compliant flow control support with software-controllable Rx thresholds and Tx pause frames Automatic cross-over detection function (MDI/MDI-X) IEEE 1588 protocol and 802.1AS implementation Power Management and Efficiency: IEEE 802.3az - Energy Efficient Ethernet (EEE) DMA Coalescing Smart Power Wown (SPD) at S0 no link/Sx no link Active State Power Management (ASPM) LAN disable function Full wake up support Advanced Power Management (APM) Support (formerly Wake on LAN) Advanced Configuration and Power Interface (ACPI) specification v2.0c Magic Packet wake-up enable with unique MAC address ACPI register set and power sown functionality supporting D0 and D3 states MAC Power Management controls Low Power Link Up - Link Speed Control Power Management Protocol Offload (Proxying) Stateless Offloads/Performance Features: TCP/UDP, IPv4 checksum offloads (Rx/ Tx/Large-send); Extended Tx descriptors IPv6 support for IP/TCP and IP/UDP receive checksum offload Transmit Segmentation Offloading (TSO) (IPv4, IPv6) Interrupt throttling control Legacy and Message Signal Interrupt (MSI) Message Signal Interrupt Extension (MSI-X) Intelligent interrupt generation Receive Side Scaling (RSS) for Windows Scalable I/O for Linux environments (IPv4, IPv6, TCP/UDP) Support for packets up to 9.5K Bytes (Jumbo Frames) Low Latency Interrupts Header/packet data split in receive PCIe v2.1 TLP Processing Hint Requester Descriptor ring management hardware for Transmit and Receive Remote Boot Option Features: Preboot eXecution Environment (PXE) flash interface support Intel iSCSI Remote Booo for Windows, Linux, and VMware Intel Boot Agent software-- Linux boot via PXE or BOOTP Windows Deployment Services, or UEFI Descriptor ring management hardware for transmit and receive Manageability Features: DMTF Network Controller Sideband Interface (NC-SI) Pass-through Intel System Management Bus (SMBus) Pass-through Management Component Transport Protocol (MCTP) over SMBus and PCIe OS2BMC Traffic support Private OS2BMC Traffic Flow Firmware Based Thermal Management IEEE 802.3 MII Management Interface MAC/PHY Control and Status Watchdog timer Extended error reporting Controller Memory Protection Vital Product Data (VPD) Support Standards: IEEE 802.3/10BASE-T, 100BASE-T, 1000BASE-T Controller Processor: Intel Ethernet Controller I210 Connectors: 1x RJ45 (Copper) Data Rate: 10/100/1000 Mbps Per Port Cabling: Category-3 or higher for 10BASE-T operation Category-5 or higher for 100BASE-TX operation Category-5e or higher for 1000BASE-T operation Bus Type: PCI-Express 2.1 (2.5 GT/s) Bus Width: PCI-Express x1; operable in x1 or greater slots Interrupt Levels: INTA, INTB, INTC, INTD, MSI, MSI-X Power Consumption: 0.81W Typical Certifications: FCC B, UL, CE, VCCI, BSMI, CTICK, KCC Dimensions (WxLxH): Full-height End Bracket: 0.709 x 2.640 x 4.755 inch / 1.80 x 6.70 x 12.07 cm Low-profile End Bracket: 0.709 x 2.640 x 3.150 inch / 1.8 x 6.7 x 8.0 cm