84*48 LCD Module White/Blue Backlight Adapter PCB for Nokia 5110 Arduino

Specification:1. "LIGHT" linked with GND, the backlight to be lit.2. Need you to compress the screen and PCB tighter, might got loose after the delivery.3 Use a 3.3V controller, otherwise the display could be quite vague.LCD5110 Module:Power supply voltage:2.7V-3.3V,5V is OK,but part of the screen becomes black when testedData interface level:2.7-5VBacklight power supply voltage:highest 3.3VInstallation diameter:2mmBacklight:White/BlueDocument for Download:Data1£®RST--------- reset2£®CE------------chip selection3£®DC-----------data/commands choice4£®DIN-----------serial data line5£®CLK------------serial Clock Speed6£®3.3V------------VCC7£®LIGHT--------- backlight control terminal8£®GND-----------power negativeFeatures:84 X 48 dot matrix LCD,can show 4 lines of charactersUse serial interface communicate with the master processor,the number of interface signal line reduced greatly, only 8 signal lines including power and GND.Support different types of MCU,such as the SPI,MCS51 serial mode 0 of AVR.Transfer rate up to 4Mbps,can full speed write display data without waiting time.Can use the conductive glue to connect the module with the printed board,without connecting cable.The metal hooks on the module can fix the module on the printed board,which is very easy to install and replace.LCD controller/driver chip has been bound to LCD chip,the volume of LCD is smallLow power supply,the working current in normal situation is lower than 200¦ÌA,and has power-down mode.Shipping Included:1PCS*Nokia 5110 LCD Disply Module