DC 12V 24V Weighing Transmitter load Cell Amplifier Weight Sensor Amplifier Load Cell Transducer 4-20ma

Description:Housing and wire connectors are waterproof design, good sealing, suitable for harsh environmentsLook beautiful, durable, anti-jamming performanceUltra- high-precision op-amp circuit, high accuracy, good stabilityThe power supply has reverse polarity protection, surge protection, overcurrent protectionSuitable for weighing, pull pressure, torque, and another strain sensor. Technical Parameters: Working voltage: DC 12-24VOutput signal: voltage (0-5V, 0-10V, 1-5V, ± 5V) 4-20mainput signal:sensor sensitivity 2.0MV/Voutput incentive:5V(E+)Operating temperature range: -20 - 80Operating Humidity: 10% RH-90% RH (non-condensing)Accuracy: better than 0.1% F.SPrecision is better than 0.05% F.S Gear selection: dial switch turn OFF, V0 output 0-5v, 1 turn to ON V0 output 0-10V1 and 2 both turn to OFF VO output 0-5v IO output 4-20MA About debugging:1 zero adjustmentFirst of all, make the system is in the idle state, adjust the marking "ZERO" potentiometer to adjust the zero offset. The multimeter is used to measure the output voltage or current, let show value as close as possible to the zero value display. Or change the magnification zero change will become big.2 gain adjustmentThe system loading a certain weight value (the recommended range: 80% ~ 100% FS), the calculation of the output current value according to the load weight and the maximum weighting value relation, using the digital multimeter monitoring output, potentiometer to adjust amplifier gain spin-labeled "SPAN".3 the retestThe system is in the idle state, measuring the zero output; loading a certain weight value, output voltage measurement whether fluoride expectation magnification If not, repeat steps 1, 2 adjust again. Package: 1 x Load Cell sensor Amplifier Transmitter