Happymodel BeecoreX FR V1.0 AIO F4 5-in-1 Brushed Flight Controller /w VTX+RX

The BeecoreX FR V1.0 is the ultimate 5-in-1 flight controller for a Brushed Tinywhoop and includes an F4 FC, VTX, ESC, frsky receiver, and betaflight OSD. This AIO FC makes building a brushed tiny whoop a no-brainer! Just add your FPV camera, brushed motors, frame, and propellers... then plug and play - no soldering required. Features 5-in-1 F4 FC, VTX, ESC, frsky receiver, and betaflight OSD No soldering required Specifications R1(RX1) Pad is used for IBUS/DSM2/DSMX signal input IR1(IRX1) Pad is used for SBUS signal input (Already inverted) R1 and IR1 Cannot be used simultaneously Mounting Pattern: 25.5x25.5mm Flight Controller (Frsky SPI RX version) Betaflight Firmware target: CrazybeeF4FR MCU:STM32F411CEU6 (100MHZ, 512K FLASH) Sensor: MPU-6000(SPI connection) Board size: 28.5 * 28.5MM Power supply: 1S battery input (DC 2.9V-4.35V) Built-in 5A(each) Brushed 4in1 ESC Built-in Betaflight OSD(SPI Control) Built-in 5.8G VTX 25mw~100mw switchable Built-in SPI Frsky receiver(compatible with Frsky_D/ Frsky_X/ S-FHSS/ Redpine protocol) Built-in 5V 1A BEC Built-in voltage detection Onboard Frsky SPI - Receiver Version SPI BUS receiver Frsky version Compatible with Frsky D8/D16 ( D8 is recommended), S-FHSS, Redpine protocol Channels: 8ch Failsafe support No ground interference ( Transmitter and receiver 1 m from the ground): 100m~200m RSSI compatible Onboard 5.8g VTX Output power: 25mw~100mw switchable Frequency: 40CH Input voltage: 3.3V 5.5V Current consumption: 300mA(type) Frequency: 5.8GHz 5bands 40 channels With Race band Smart audio ready VTX POWER=1 (25mw) VTX POWER=2(50mw) VTX POWER=3(100mw) Recommend to use 50mw Recommend Runcam Nano3 camera, plug and play Includes 1x Happymodel BeecoreX Fr V1.0 AIO F4 5-in-1 Brushed Flight Controller /w VTX+RX 2x Connecting Wires 4x Damping Balls 5x Screws