ATmega328P DIY arduino Learning Kit FT232RL 22pF 100nF 16MHz crystal breadboard

Introduction The Atmel® picoPower® ATmega328/P is a low-power CMOS 8-bit microcontroller based on the AVR® enhanced RISC architecture. By executing powerful instructions in a single clock cycle, the ATmega328/P achieves throughputs close to 1MIPS per MHz. This empowers system designer to optimize the device for power consumption versus processing speed. Feature High Performance, Low Power Atmel®AVR® 8-Bit Microcontroller Family • Advanced RISC Architecture – 131 Powerful Instructions – Most Single Clock Cycle Execution – 32 x 8 General Purpose Working Registers – Fully Static Operation – Up to 20 MIPS Throughput at 20MHz – On-chip 2-cycle Multiplier • High Endurance Non-volatile Memory Segments – 32KBytes of In-System Self-Programmable Flash program Memory – 1KBytes EEPROM – 2KBytes Internal SRAM – Write/Erase Cycles: 10,000 Flash/100,000 EEPROM – Data Retention: 20 years at 85°C/100 years at 25°C(1) – Optional Boot Code Section with Independent Lock Bits • In-System Programming by On-chip Boot Program • True Read-While-Write Operation – Programming Lock for Software Security • Atmel® QTouch® Library Support – Capacitive Touch Buttons, Sliders and Wheels – QTouch and QMatrix® Acquisition – Up to 64 sense channels Datasheet   DIY kit Include:   1 x ATmega328p IC Chip 1 x 140pcs Solderless Breadboard Jumper Cable Wire Kit U Shape 1 x 16MHz crystal oscillator 1 x 10 KOhms resistor 1 x 330 Ohms 2 x 22pF capacitors 1 x 100nF capacitor 1 x Tactile push button 1 x testing LED RED 1 x FT232RL FTDI serial adapter module 1 x Half+ breadboard 6 x dupont cable wires M-F   Technical support is NOT included in this auction