Arduino Adapter For Raspberry Pi

Arduino is a massive ecosystem, if theres a way for the Raspberry Pi GPIO interface to adapt to Arduino pinouts, it is possible to use the Pi together with vast Arduino shields and hardware/software resources. The ARPI600 is just intended for this.Whats more, the ARPI600 also support XBee modules, make it easy to add wireless feature to your great project.Supported Pi:Raspberry Pi 1 Model A+Raspberry Pi 1 Model B+Raspberry Pi 2 Model BFEATURESCompatible with Arduino UNO, Leonardo, easy to connect with various Arduino shieldsXBee connector for connecting various XBee modulesSensor interface for connecting various sensorsOnboard USB TO UART for serial port debugging, also can be configured as XBee USB adapterOnboard ADC, 10 bit, 38KSPS, 11 channels (6 channels for Arduino interface, 5 channels for sensors)Onboard RTCSPECIFICATION1£®Arduino connector : for connecting Arduino shields2£®ICSP interface : Arduino ICSP3£®XBee connector : for connecting XBee communication modules4£®Sensor interface : for connecting sensors5£®Raspberry Pi connector : for connecting Raspberry Pi6£®USB TO UART7£®TLC1543 : AD converter8£®PCF8563 : RTC9£®CP210210£®32.768KHz crystal : for RTC11£®Power indicator12£®XBee state LED13£®XBee and Arduino interface RESET button14£®XBee EASYLINK button15£®RTC battery holder : for CR1220 button battery16£®TLC1543 reference voltage configuration jumper17£®RTC jumper18£®UART jumperwhen connecting P_RX and CP_TX, P_TX and CP_RX respectively, USB TO UART is connected to Raspberry Pi serial portwhen connecting XB_RX and CP_TX, XB_TX and CP_RX respectively, USB TO UART is connected to XBee serial portwhen connecting XB_RX and P_TX, XB_TX and P_RX respectively, Raspberry Pi serial port is connected to XBee serial port19£®Arduino AD selection jumpershort 2 and 3 : Arduino A0-A5 as AD inputshort 1 and 2 : Arduino A0-A5 as digital control20£®Arduino I2C selection jumpershort the jumper : Arduino A4-A5 as I2C control (the A4-A5 of Arduino AD selection jumper should be opened)21£®Arduino SPI selection jumpershort 1 and 2 : Arduino D11-D13 as SPI control (default)short 2 and 3 : Arduino D11-D13 as digital controlDOCUMENTSPlease visit wiki page for more info about this product.For technical support, please post your questions to our forumTechnical detailsDimensions 150mm x105mm x29mmWeight G.W 101gBattery Exclude