★X-CAM A10-3H for GOPRO 3 Axis Gimbal

Parameters Weight:  280g ( without GOPRO ) Stabilization frequency:  5200Hz Input voltage:  7.4v ~ 16.8v ( 2S ~ 4S Lipo ) Tilt travel:  +-90 degree; Roll travel:  +-45 degree YAW travel:  360 degrees unlimited rotation AV ouput & Charging Module has been insided Does not need any Auto Pilot System supporting 3 Gyro sensors & 1 Position sensor inside Supports automatic location function The S-BUS output provides full functions, all function has been defined channel number: Channel 1 : ROLL Control Channel 2: Return to HOME Channel 3: TILT Control Channel 4: YAW Control Channel 5: Mode switch   The recommend operation ways   1. Single person: Just connect PPM channel for switch HEAD FOLLOWING , HEAD LOCK and AUTO BACK TO HOME, does not need to connect S-BUS channel, One receiver can be used.   2. Two persons: Does not need to connect PPM channel, only S-BUS output channel provides full functions. But needs 2 receivers     Notice: It does not need provide power to the receiver when you using two person mode, the A10-3H controller will provide the power to the receiver via the S-BUS. Announcements                                                                                                                  1.        Do not touch the gimbal during the initialization after turn on, Keep the gimbal in quietude 2.        Do not use BEC for the gimbal power, pls use 2~4S Lipo battery 3.        Strongly suggest using 12mm tube to mount the gimbal 4.        Make sure the center of gravity of the gimbal  is correct before using.