PES-2602 4-Port Digital Input Board for PHPoC Shield 2

 The PES-2602 4-Port Digital Input Board is a Smart Expansion Board for PHPoC P4S-347 or P4S-348 V2 Shields which is designed to monitor the on/off state of high-voltage devices. After stacking on a PHPoC P4S-347 or P4S-348 V2 Shield with an Arduino Uno or Mega, this board can be controlled by Arduino using the PHPoC library. Each 4-Port Digital Input Board carries four photocouplers. A single Arduino Uno/Mega can support multiple 4-port Digital Input Boards. Two different types of terminal blocks are available, based on the direction of the terminal screws. S-type can be screwed from the side, convenient when the multiple boards are stacked. T-type is screwed from the top of the board. The wire termination blocks are on the side of the board in both models. Smart Expansion boards for PHPoC P4S-347 or P4S-348 V2 Shields provide the additional hardware and firmware to boost Arduino Uno and Mega microcontrollers with advanced capabilities (e.g. control high-voltage devices, control/monitor motors with high accuracy). They communicate with Arduino Uno/Mega via a defined set of commands and need to be stacked above a PHPoC [WiFi] Shield 2 (P4S-347 V2 or P4S-348 V2), firmware version of 1.4.0 or above, in order to interface with Arduino. Specifications 4-port electrically isolated Photocouplers WET/DRY contact, NPN/PNP transistor input Maximum Voltage: DC 30V 1x8 5mm Pitch Terminal Block: S type, T type DIP Switch to Set Address (ID) Delivery is stock to 2 weeks, if the item is out of stock, please contact us for availability.  Documentation & Resources    PES-2602 4-Port Digital Input Board for PHPoC Shield 2 Web Page