NixTrainz Decoder Buddy Mini 2.2K Ohm Resistors NTZ8

The Decoder Buddy Mini was developed to fit into smaller steam and diesel applications.  There has also been interest in HOn3 and S-Gauge applications. This mother board does not include the 21 Pin Decoder. This mother board requires soldering. This printed circuit board is NOT INTENDED FOR USE IN A DC SYSTEM.  However, if the decoder you are using supports DC operation it should work. The Mini comes with  “2.2k” Ohm resistors.  The mother board includes: One 21 Pin Decoder receptacle Two pairs of track input pads One pair of motor output pads One set of stay alive pads (U+, GND and if necessary, a third control wire) If using an ESU ‘Power Pack’ we recommend A10 as mentioned below. Two logic outputs to control a Power Pack, smoke unit(s) or servo. The two logic output pads are 5 volt outputs with no resistors and controlled by A10 and A6 as labeled. One pair of speaker pads The correct headlight orientation is shown on the Mini.