Skull Ice Cube Maker

Material: SiliconeSize:: 18.2*12.7*4cm/7.17*5*1.57''Color: Black How to use it: – Before using your new tray, be sure to wash to wash thoroughly with soap and water – Fill the bottom tray nearly full of water (leave about 1 cm unfilled) – Then set the bottom tray on an even surface in your sink and press the lid tray down into the bottom tray until it is sealed (Note: The excess water will escape through the 6 vent holes at the top of each ball) – When full, gently press down on the top of each mold to force out enough water to give a slight air gap at the top of each ball for expansion -This step is important so your ice balls will form properly without cracking – Need to leave room for expansion – Do not worry about excess water in tray. Let it freeze with the mold – Lay flat in freezer for 5+ hours – After freezing please follow these steps: – Before removing mold lid, break all ice around balls using a twisting motion…with lid still on – If you do not, there will be Saturn-like