HALJIA 3Pcs DRV8833 1.5A 2 Channel H Bridge DC Gear Motor Driver Module Board Compatible with 3D Printer Arduino

The motor driver can control up to two DC motors at a constant current of 1.0A (4A peak). Two input signals (IN1 and IN2) can be used to control the motor in one of four function modes - CW, CCW, short-brake, and stop. The two motor outputs (A and B) can be separately controlled, the speed of each motor is controlled via a PWM input signal with a frequency up to 100kHz.Note: However, when using the board at currents up to 0.6A, it may be necessary to improve thermal performance with a heat-sink. Features:Driver Chip: DRV8833Power supply voltage: VM = 2.7-10.8VOutput current: Iout=1.0A(average) / 4A (peak)Standby control to save powerCW/CCW/short brake/stop motor control modesBuilt-in thermal shutdown circuit and low voltage detecting circuitAll pins of the DRV8833 break out to 2.54mm spaced pins, and it can be plugged onto the breadboard.Filtering capacitors on both supply linesGreat for DIY and smart car projectsInstructions: ULT PIN:mode set.Low level is sleep mode OUT1,OUT2:1-channe