HALJIA Openlog Blackbox Flight Data Recorder for Cleanflight CC3D Naze32 F3 Flight Controller with Pins Flash ATMEGA328P

Can be used for Multiwii or arduino breakboard debugging,also enable you to configure Bluetooth module,OSD, Sik radio and GPS,it is an indispensable tool for RC field. USB to TTL RS323 UART converter module uses imported chips,compatible with FT232 circuit.Support 5V and 3.3V devices the board has contained the openlog_blackbox_v2.0 firmware. Flight conroller transmits your flight data information on every control loop iteration over a serial port to an OpenLog to be recorded The OpenLog(blackbox) can store or log huge amounts of serial data and act as a black box of sorts to store all the serial data that your project generates Memory format is FAT32 and supports up to 64GB of memory Technical Parameters:1 Memory format is FAT32 and supports up to 64GB of memory2 Simple command line interface, UART serial interface3 Change the tf card's config file on your computer (if it's a new card, insert the card for the first time after power-on, the config file will be created automatically)to change settings such as baud rate. You do not need to buy any specialized tools to change the serial settings4 three modes: new, add, command5 baud rate can be set 300-1000000bps6 the minimum connection to ensure the operation:vcc, gnd, rx7 two led lights indicate the running status8 input voltage 3.3V to 12V, preferably 3.3 to 5V.9 idle current 2ma, the maximum recording rate 6ma.10 The default bootloader is pro mini atmega328P 5V 16mhzPacking List:1*Openlog Blackbox Flight Data Recorder