Cantek JEN60 Drawer Notcher

The Cantek JEN60 Drawer Notcher is designed to both notch and drill drawer boxes to install undermount soft-close drawer slides.  The operation of the machine is simple with a self-indexing drilling unit that’s determined by the position of the drawer for either left or right notching.  With a cycle time of approximately 10 seconds per drawer, you can achieve a high throughput and save time for other important tasks.Key Advantages• Pneumatic cutter & drill stroke by foot pedal operation. • Cutter stroke and drill speed are adjustable for optimum finish results • Drill will automatically position for both left and right drawer notches by activating a switch in the fence • Machine will not cycle unless a drawer is up against the switch for safe operation • Insert knife cutterhead with solid carbide inserts for optimum finish results and long tool life • 2 ¼" (57mm) wide cutter allows for a wide range of undermount slides • Comes with insert cutterhead with inserts and ¼" (6.3mm) solid carbide drill bit. • Capable of notching up to 220 drawer boxes (both left and right) per hour.Specifications Main cutter motor 3 HP (230/3/60 or 460/3/60) | 2HP (230/1/60) Notch dimensions 2 ¼" (57mm) x 0.5" high Cutterhead diameter 10" Drill diameter ¼" Table size 49" x 22" Table height from floor 32" Dust port 2 x 4" (1,340 CFM requirement) Compressed air required 90 – 100 PSI Machine dimensions 48" x 37 ¾" x 39 ¾" Machine weight 506 lbs. Shipping dimensions 53" x 42" x 44" Shipping weight 612 lbs. Electrical requirements 230/3/60 = 9amps460/3/60 = 4.8amps230/1/60 = 10amps575/3/60 = 3.9amps