PM06D Power Module (14S)
holybro.com
Electronics / Circuit Boards & Components

PM06D Power Module (14S)

$33.59
{{option.name}}: {{selected_options[option.position]}}
{{value_obj.value}}
Store Logo

Holybro Store

View Store

Note- PM06D is supported by PX4. For Ardupilot, it is supported in version 4.4 and later.  - This PM uses I2C digital signal data output and is not compatible with flight controller that uses analog PM such as the Pixhawk 6C & Mini, Pixhawk4 & Mini, pix32 v5, or Durandal flight controllers. PM06D provides a regulated power supply for your Pixhawk® 5X & 6X from the battery, as well as current consumption and battery voltage measurements, all through a 6-pin cable. It has built-in power distribution, allowing you to power your ESC and FC with the same board.The on-board switching regulator outputs 5.2V and a maximum of 3A from LiPo batteries up to 14S. The Power Module comes completely assembled with an XT60 connector and a capacitor. The Molex 2.00mm pitch CLIK-Mate Wire-to-Board connector is rated for 3.0A current per contact. Specification Input voltage: 2S- 14S PCB Cont. Current Rating: 70A PCB Burst Current Rating: 120A (<60 Sec) Max current sensing: 327A Voltag

Show More Show Less