DORMAKABA® Bottom Door Patch Fitting with Bottom Insert For 3/4" Glass

Product Overview  DORMAKABA® Bottom Patch Fittings are designed to be used with our bottom door pivots or floor closers and fit snugly in the lower corner of the glass panel, requiring a hole and cut-out in the glass. They are available in brushed or polished stainless steel finishes. Here are the specifications to be aware of: 2-3/4" (70 mm) Pivot Setback For 3/4" (19 mm) Glass  Use Monolithic Tempered Glass When using this hardware, please adhere to the following guidelines: Maximum Height: 102" (2.59 m) Maximum Weight: 194 Lbs. (88 kg)  Maximum Width: 42" (1.09 m) If the door exceeds any of these limitations, it is recommended to use full door rails. Glass fabrication requires: One 3/4" (19 mm) Diameter Hole and Corner Notch These fittings come with a template and instructions and adhere to the following product warning: Not suitable for use with laminated glass. Furthermore, please note the Stainless Steel Advisory: While stainless steel is resistant to corrosion, it is not rust or stain-proof. It is recommended to perform periodic maintenance to maintain its factory finish. For further details, please refer to the Stainless Steel Disclaimer in the Technical References section below.