P2M Rear Upper Control Arms FR-S 13-16 / BRZ / GT-86 13-2020 WRX / STI 08-21 | P2-RUCA2086-HC

Fitment Information: Scion FR-S 2013-2016 Subaru BRZ 2013-2020 Toyota 86 2017-2020 Subaru WRX 2008-2021 Subaru STi 2008-2021 The latest Gen 2 arms do not have the ABS wire bracket. P2M removed the bracket because they beefed up the tubing, and depending on the camber adjustment, the ABS bracket in stock location might actually bind. With the Gen 2 arms, you can zip tie the ABS wires after an alignment is done so that the wires are secured without binding. P2M rear upper control arms(RUCA) for the Scion FR-S, Subaru BRZ, WRX, STI can be useful for serious track racers that wants to dial in their camber and wheel base settings on the track. When you combine the P2M rear upper control arms with full adjustable rear suspension links, you will have precise adjust ability to your car's rear end suspension geometry. The P2M RUCA's are made from S45C steel tubing, 3pc teflon based rod end w/dust boot and a thick powder coated blue finish. CAMBER ADJUSTMENT: By default can go up to -6 negative camber. The arm is setup for NEGATIVE CAMBER adjustment ONLY. Please DO NOT run stock camber (0 to -1 deg) camber with this arm as it can be overly extended. It is RECOMMENDED to run between -3 to -6 deg of camber with this arm for preferred setting. By removing the first jam nut (nut in front of the turnbuckle) will gain additional -2 deg (for approximate total -8 deg camber) By removing the last jam nut (nut in the BACK of the turnbuckle) will gain additional -3 deg (for approximate total -9 deg camber) By removing BOTH jam nuts will achieve approximate -10 to -11 deg of camber ** DISCLAIMER: FOR ANYONE REMOVING THE JAM NUTS TO ACHIEVE NEGATIVE CAMBER PLEASE MAKE SURE THE ARMS MUST BE LOCKED INTO THE SHORTEST POSITION. DO NOT EXTEND THE ARMS WITHOUT JAM NUTS IN PLACE.