POE Powered 3 Port Switch & Network Cat5 Cat6 Midspan Cable Range Extender Pass Through Repeater for IP Cameras - Run Cables up to 1148

POE POWERED 3 PORT 10/100 UNMANAGED POE SWITCH - This unique switch is powered by incoming POE power from your POE switch or POE injector. It has 1 POE input that passes POE and Data through to the 3 POE Outputs. Since it does not require traditional AC power, this gives the user the ability to install this POE switch anywhere without the need for a nearby power receptacle. POE AND DATA CABLE RUN EXTENDER - Not only does this act as a standard POE switch, it also gives you the ability to surpass the limitations of a standard 100 meter cable run. This unit can extend your incoming Data and POE transmission up to an additional 100 meters on all 3 output ports. Turn on the optional "Extend Mode" to boost the POE and Data Transmission on ports 2 and 3 to an incredible additional 250 meters (data rate will drop to 10 Mbps on these ports when enabled). OPTIONAL "VLAN" AND "EXTEND" MODE - There are 2 optional modes that can be activated by a dip switch on the unit. VLAN MODE: This isolates the 3 output ports from communicating and sending data to each other and each of these ports will only be able to communicate with the POE Input uplink port. POWERED BY INCOMING POE - This switch operates best with 30 watts of incoming POE, but can function at reduced capacity with lower wattage. It uses 5W for itself and channels remaining power to the 3 outputs. Compatible with standard POE types (802.3af/at/bt), utilizing max 30W. Output wattage budget is 25W total, shared across 3 ports (up to 25W per port). LOW PROFILE AND WALL MOUNTABLE - The unit is small and unassuming and can be conveniently installed on a flat surface or be wall mounted using the included wall mount ears. Size is only 8.25cm Wide (11.35cm Wide with mounts installed) x 5.5cm High x 2.4cm Deep Downloads: Spec Sheet