Combat Robot Servo - 32kg-cm True 200 Degree with Stall Protection

Looking for the perfect servo for your next bot? Look no further! Most of the 25kg and 35kg servos on the market flat out lie about their specs. Those labeled for 270 degrees barely provide 180, and the torque ratings vary from misleading to flat-out lies. Not only will this servo deliver the angle and torque that it says on the tin, but it’s specially optimized for use in combat robots. By implementing stall protection, the current draw of this servo will limit itself to about 0.6 amps after it is stalled continuously for more than 8 seconds. Remove the stall condition and after a few seconds, you can expect to get more power once again over and over, without needing to worry about smoking your servo motor! Torque: 32 kg-cm (444 ozf-in, 27.8 lbf-in) @ 8.4V (Full charged 2S LiPo). For best results, pair with our Steel Servo Horn! Voltage: 5-8.4 Volts (you MUST use a Motherboard or BEC to power this servo if your battery is 10V/3S or higher) Current: 0.1 amps idle (typical draw depend