Shellplate Bearing Kit w/ low mass ball for Dillon 1050

We have updated the SPACER and is now thinner than the older style. All new orders will have 0.0625" Thick Spacers. If you need an OLD 0.09375" Thick Spacer please contact us.  Install Tip and Advise: *****With the bearing kit installed it is very possible with very fine grain powder and near full casings to still have powder spillage but nowhere near what you would get without one installed. A quick install and tightness tip would be: The shellplate nut should be tight enough to where the index pawl "has to" cycle the shellplate into position 100% and "does not" allow the index ball to snap the plate into position. So basically the operator's upward stroke determines the speed and harshness of the indexing. Most powder spillage is due to the plate snapping into position towards the end of the stroke by the index ball.There are too many other variables such as vibration, case-to-shellplate fitment, case fill percentages for each powder, powder cop pulling powder out of casings etc that