Compute Module IO Board Plus Composite Breakout Board for Raspberry Pi CM3/CM3L/CM3+/CM3+L Custom PCB ultrasonic cleanser pcba

  Compute Module IO Board Plus, Composite Breakout Board for Developing with Raspberry Pi CM3 / CM3L / CM3+ / CM3+L Overview The Compute Module IO Board Plus is a development board which you can plug a Raspberry Pi Compute Module into, and make use of the resources of Pi more flexibly. It is compatible with the Compute Module IO Board V3 from the Raspberry Pi Foundation, along with various common use components. Features Compatible with the Compute Module IO Board V3 from the Raspberry Pi Foundation Raspberry Pi GPIO header, for connecting sorts of Raspberry Pi HATs Ard connectivity, also supports Ard shields 1-WIRE interface, for connecting single-bus devices like DS18B20 4x keys, 4x LEDs, 1x Buzzer, for I/O testing Onboard USB HUB, allows connecting more USB devices IR receiver, IR remote control is available Onboard USB TO UART, for serial debugging Sensor interface 10-bit ADC, 38KSPS, 11-ch (6-ch for Ard interface, 5-ch for sensors) 16-bit DAC, 2-ch Onboard RTC, one of the most common and useful functions What's Onboard   Compute Module interface: for connecting Compute Module (CM3 / CM3L / CM3+ / CM3+L) Compute Module GPIO header: breakout all the Compute Module pins Raspberry Pi GPIO header: for connecting Raspberry Pi HATs CSI interface: camera ports, for connecting Raspberry Pi Camera DSI interface: display ports, for connecting Raspberry Pi LCD HDMI port USB ports: for connecting USB devices USB SLAVE interface: allows you to burn system image in to Compute Module 3 USB TO UART interface: for serial debugging Ard header: for connecting Ard shields AD/DA input/output screw terminals 1-WIRE interface: for connecting single-bus devices like DS18B20 Sensor interface Power port: 5V 2.5A FE1.1S: USB HUB chip 12MHz crystal CP2102: USB TO UART converter Micro SD card slot: insert a Micro SD card with pre-burnt system, to start up Compute Module 3 Lite TLC1543: AD converter DAC8552: 16-bit DAC, 2-ch DS3231: high-precision RTC chip, I2C interface RTC battery holder: supports CR1220 batteries Voltage regulator: 3.3V / 2.5V / 1.8V  LFN0038K: IR receiver Buzzer Power indicator ACT indicator: indicating the Micro SD card status User LEDs User Keys BOOT selection EN: enable the PC to access SD card/eMMC through USB SLAVE DIS: the Compute Module will boot from SD card/eMMC VGx power selection: config the I/O level USB HUB enable jumper: HUB enable and USB SLAVE power selection ADC/DAC configuration: config the power supply and reference voltage of ADC/DAC Peripheral configuration: config the control pins of UART, user keys, user LEDs, 1-WIRE interface, IR receiver, and buzzer Ard AD selection connect 1 and 2: Ard A0-A5 as digital control pin connect 2 and 3: Ard A0-A5 as AD input Dimensions Compute Module IO Board Plus x1