Custom New 1CH 7V 9V 12V 24V DC DIY wifi Light Smart Switch Home Automation Module, RF 433mhz Remote Control Wireless Relay Switches Manufacturer
New 1CH 7V 9V 12V 24V DC DIY wifi Light Smart Switch Home Automation Module, RF 433mhz Remote Control Wireless Relay Switches Packing List: 1 X 1 Way 7-24V DC Switch (Does not include remote control) Features: 1 Support WIFI network. (Attention: The switch module must keep connect with wifi service.) 2 Support 433mhz RF remote transmitter control.(Can learn most 433.92mhz transmitter, like chip 2260,2262,2264,1527. Allow 16 different transmitters to control ) 3 Support three working modes: momentary, interlock and self-lock control. 4 Support Max 8 timing tasks for each added device. 5 Support status tracking, home appliances status timely feedback to your App. Product Specification: 1 Input voltage: DC 7-24V 2 Maximum load: 10A 3 Working temperature: 0-60 centigrade 4 Control method: WIFI +433mhz RF + Manual Button Control 5 Channels: 1 Way 6 Switch size: 105*46*25mm 7 Passive output, commonly used as a mechanical switch. 8 Remote Frequency:433mhz 9 Remote battery: A 23A/12V battery (build-in a remote) How to connect phone with switch? 1 Make sure the switch and your phone under the same wifi service. 2 Download and install the software of “eWeLink” from APP store or Google play store. 3 Follow “eWeLink” instructions to register an account on it. 4 Log in your account of “eWeLink”. 5 Press manual control button for 5 seconds until you see the D3 light flash quickly, release it. Then add device on mobile phone by eWeLink APP according its introduction. 6 Now you can use your phone to control the switch under 2G/3G/4G signal. How to learn 433mhz transmitter? Step 1:Supply 7-24V power to the relay. Step 2: Press “learning button” until you see D3 flash 1 time, release it. Then press remote transmitter key, the D3 flash 3 times quickly. OK. How to clear 433mhz signal? Step 1:Supply 7-24V power to the relay. Step 2: Press “learning button”, you will see D3 flash 5 times at first, and then flash 3 times quickly. OK. How to set working mode? The relay is self-lock as default working mode. Supply 7-24V power to the relay. 1: Press “learning button” until you see D3 flash 2 times, release button, now it is self-lock. 2: Press “learning button” until you see D3 flash 4 times, release button, now it is momentary. What is the difference between working mode? 1 Momentary:Press remote button A, receiver CH1 ON. After 1 seconds, receiver CH1 OFF 2 Self-lock: Press remote button A , receiver ON. press button A again, then receiver OFF Company Information Buyer feedback