ORI CLS-3//88 R2 (Extra Parts) (In-stock)

Assembly Instructions: https://www.ori-club.com/instruction PCB Guidance: https://www.support.mechlovin.studio/tkl/ori-cls-388 BUY AN ORI-CLS//88 KIT! Introduction Check out some of the streams! Lulzthax | Alexotos | Markerchun Quality Disclaimer There will be hook marks inside the parts after going through the anodize process, I accept no more than 3 dot in 1 area. Each dot should not exceed 2.5mm. Hook marks are only allowed to appear in invisible areas after the build (plate and switch installation)There may be minor machining/tooling marks on internal faces.The anodizing process will cause the color variation of the top part and bottom part to not 100% match under special lighting conditions. However, I would still accept a very slight difference, especially as the design of the CLS-3 is that the top part will snap over the rest.The part is made of brass and sandblasted surface treatment, will have a uniform yellow color, the gain of the surface is relatively consistent. No scratch