Rear Wheel Arch Repair - FHC & 2+2 - Outer - LH

This panel is patterned after an original Series 1 E-Type, but is the same on all 6-cylinder cars - Series 1, 1.5, and 2. It is recommended for Coupes and 2+2's where the wheel arch has an inner wheel-well that traps moisture and rusts along the edge, but this piece CAN be used for roadsters as well. (see our other panel specifically for Roadsters...) It is correct in every dimension - including the thickness, the location and angles of the bends and flanges, and curvature.We recently went to GREAT LENGTHS to make sure that these panels are EXACT! These have been available for years from other suppliers, but I must say that their is NO COMPARISON between theirs and ours!  For starters, theirs is almost dead flat out of the box, and does not have the proper curvature of the body...  I also do not like the radius of their edge - it is too soft - and obviously hand-hammered - so it is "lumpy" on top of that. This all means that your body man is going to be finishing off the edge properly