Holybro PM06 V2 Power Module

Holybro PM06 V2 Power Module Description: This PM06 Power Module supplies clean 5.2V to flight controller from the battery and provides current consumption and battery voltage measurements via analog signal through a 6 Pin JST-GH cable, along with integrated power distribution for 4 ESCs. It comes with pre-soldered wires, capacitor, and XT60 connector. Specifications：  Input voltage (10S version): 2S-10S Input voltage (14S version): 2S-14S PCB Cont. Current Rating: 70A PCB Burst Current Rating: 120A (<60 Sec) Output: DC 5.2V & 3A Max  Ouput Max Power : 18W Voltage Divider: 18.182 Amperes per Volt: 36.364  Please Note:  The XT60 Plug and 12AWG wire that are pre-soldered on the board is rating for 30A continuous current and 60A burst current (< 60 Seconds). If a higher current is being used, the plug type and wire size should be changed accordingly. You can refer to this chart for reference. This PM02 Power Module uses analog data output and is not compatible to the Pixhawk 5X & 6X (Requires a digital PM like PM02D).  Mechanical Specification: Dimensions: 35x35x5mm Mounting hole: 30.5mm*30.5mm Weight: 24g Pin Map: Setup guide for PX4 & Ardupilot can be found in the Holybro Doc here. Package Includes 1x  PM06 Power Module 1x  JST GHR 6pin 1.25mm pitch cable