Pipehorn Signal Clamp

Pipehorn 800 Signal Clamp The Pipehorn signal clamp is designed for jobs where a direct connection is not possible. Simply place the clamp around the sheath of the line and let the transmitter induce a signal without a direct connection. The signal clamp also has a threaded fitting on the handle, which allows it to be attached to a hot-stick for lines that are out of easy reach (stick not included). SET-UP INSTRUCTIONS Perform a quick system check of your Pipehorn 800 series pipe and cable locator by first plugging your clamp into the transmitter jack. When turned ON, the transmitter should emit a steady high pitch tone indicating a good battery and good signal output. Select low-frequency on your receiver (if using an 800-HL) and set the sensitivity knob precisely at 2. With the clamp laying on the ground, place the tip of the receiver wand into the ring. A beeping tone from the receiver indicates the clamp’s low-frequency is operational. Next, select high-frequency on your receiver.