Q-Seal 290 Loop Sealant Gray
Q-Seal 290 Loop Sealant (30 Fluid Ounce Cartridge) Shelf Life is 1 year from Manufacturer Date. **Please Note loop sealants can only be shipped UPS ground and only to addresses within the United States** *** THESE ITEMS CAN ONLY BE SHIPPED VIA UPS GROUND OR LTL *** Q-Seal 290S Detector Loop Sealant is a one component thixotropic moisture curing polyurethane sealant. It is designed for use in both asphalt and concrete pavement to provide a weather and chemical resistant waterproof seal. USES QSeal 290S is primarily used as a protective seal for traffic detector wire loops employed in actuated intersections. It may be used as a sealant for saw cuts in concrete or asphalt surfaces. Q Seal 290S will skin over in approximately 3 hours at 77F and 50 R.H. At temperatures below 77F this product will take proportionately longer time to cure. At temperatures above 77F it will take a proportionately shorter time to cure. SURFACE PREPARATION The substrate should be dry, dust free and as smooth as possible before installation of Q-Seal 290S. It is recommended that ambient temperatures at time of sealant application should not exceed 100�F or fall below 36F. It is recommended that Q-Seal 290S be applied by using a pressurized dispensing system, allowing for positive injection of Q-Seal 290S into the saw cut to properly encapsulate the loop wire. Normally the dispensing system consists of a 10:1 ratio pump with air regulator, gauge and air valves. The primer is an elevator with a follower plate that should be resistant to aromatic hydrocarbons. The hoses used should be Teflon lined with stainless steel cover. The flow gun itself should be a 6000 psi extrusion flow gun with various wand attachments. To apply the 30 fl. oz. cartridge, use a manual or air-operated caulking gun. *** THESE ITEMS CAN ONLY BE SHIPPED VIA UPS GROUND OR LTL *** CLEAN UPUse Chemque solvent S-235. Caution: Clean equipment after use. Use Chemque Q-CLEAN to remove sealant from your hands. In cases where the loop is to be installed in the road structure prior to the placement of the final asphalt wearing course, please contact Chemque for recommendations. Q-Seal 290S Detector Loop Sealant exhibits exceptional chemical resistance to the following chemicals: * De-icing salts * Gasoline * Hydraulic Brake Fluid * Motor Oil * Sodium Chloride (5%) SAFETY AND HANDLING PRECAUTIONS< Contains MDI (methylene diisocyanate). Keep away from heat and open flames. Use only in well ventilated areas. Do not breath vapors. In case of contact, immediately flush eyes or skin with plenty of water for at least ten minutes. If contact is made with eyes, get immediate medical attention. *** THESE ITEMS CAN ONLY BE SHIPPED VIA UPS GROUND OR LTL *** *** THESE ITEMS CAN ONLY BE SHIPPED VIA UPS GROUND OR LTL *** We have 10 years experience working on these products in the field. Please contact us if we can be of any assistance! *** THESE ITEMS CAN ONLY BE SHIPPED VIA UPS GROUND OR LTL ***