Qiachip DC6-30V 2CHANNEL RECEIVER INSTRUCTION Relay Circuit Receiver Module 433MHz DIY Wireless Receiver Remote Control Switch and RF Remote Controls Switch No Disturb Light Door Control KR2402A &KT16
Package Included:Receiver module (KR2402-4) * 1 (including shell)EV1527 remote control * 1 (not cloned) Technical Data: 1.Input Power: DC 6-30V 2.RF Frequency: 433.92MHZ 3.Standby Current:8.5MA 4.Load power: 1100W 5.Receiver sensitivity: -108dBM 6.Operation mode:Momentary Mode,Toggle Mode,Toggle Mode 7.Output signal: output a switch signal 8.Support remote type: Learning code （1527） 9.Modulation mode: ASK 10.Working temperature:-10 ~ +70°C 11.Size: 68*48*18（mm） Product Instruction Symbol description: G ----Power - V ----Power + NO ---- Often on COM ---- Public end NC ---- Normal close end N ---- Zero Line L ---- Fire Line LED ---- Indicator Light Learning button ----- Learning Button **Note** After clearing the stored transmitters, all transmitters will need to be relearned by the receiver. Working Modes explanation: Momentary Mode： Push the remote button , the relay activates, release the remote button the relay deactivates. Toggle Mode: Push and release the remote button , the relay activates. Push and release the remote button again and the relay deactivates. Clearing All Stored Transmitters: **Note** After clearing the stored transmitters, all transmitters will need to be relearned by the receiver. Push the learning button on the receiver 8 times , and the codes will be cleared . Learning the transmitter :(momentary Mode) Programing a 2 button transmitter as momentary mode transmitter. STEP 1 Push and release the learning key on the receiver ONCE. Wait for a moment , the LED will turn off , indicating you entered the learning state. STEP 2 Push and release the first button on your transmitter, the LED on the receiver board will flash on then off indicating the button was learned. STEP 3 Press and release the second button, watching the LED go on and off again. Wait 3 seconds, the LED will turn on again , indicating system is ready for use. Learning the transmitter : ( Toggle Mode ) Programing a 2 button transmitter as toggle. STEP 1 Press and release the learning key on the receiver TWICE. Wait for a moment , the LED will turn off , indicating you entered the learning state. STEP 2 Press and release the first button on your transmitter, the LED on the receiver board will flash on then turn off. Indicating the button was learned. STEP 3 Next press and release the second button, watching the LED go on and off again. Wait 3 seconds, the LED indicator will turn on again , indicating system is ready for use **Notice** two button transmitters can only be used as toggle or momentary. One mode per 2 button transmitter. (Please note: You let the control panel to learn the remote control, you must press the "A" and "B" button; Rather than just pressing one of them ) However you can program another transmitter in the other mode. Manual