Immerse Reverberator Mk II
Eight Stellar Stereo Reverbs — Zero Learning Curve The Immerse Mk II raises the bar with eight rich stereo reverbs in one easy to use pedal. No user manual required. Experience studio-quality tone that can be used with instruments of all stripes. Features High-quality buffered bypass, perfect for placing at the end of the signal chain Trails switch Kill Dry switch for parallel effect loops Inputs/outputs can be used mono (#1) or stereo (#1 and #2) Analog dry signal for low noise and zero latency Small, pedalboard-friendly footprint Requires standard 9V pedal power supply (not included) Designed and manufactured in California USA Effects The Immerse Mk II is packed with eight versatile reverb effects: W3T (Wet v3) — Our flagship reverb algorithm is smoother and more three-dimensional sounding than ever before. With adjustable pre-delay, it enhances what you play without covering it. Plate – Bright and diffuse like a studio plate reverb. Hall – The lush, open sound of a concert hall with adjustable modulation depth for achieving deep modulated tones. Spring – The distinctive twerp of a tube-driven spring reverb. With adjustable modulation speed, it can achieve a vibrato-spring sound. Sustain – A new algorithm built on the W3T reverb. This magical, versatile effect can be configured as a sustainer or infinite reverb. Echo – Combining the W3T reverb with stereo echo. Detune – Adds a detuned double of the dry signal with reverb. The blend control adjusts the amount of detune vs. detuned reverb. Shimmer – Reminiscent of a synth pad that follows what your instrument plays, this effect combines the best qualities of our previous shimmers. Controls Effect Select Mix, from 100% dry to 100% wet Reverb Depth (+Echo Repeats) Effect Dependent Control 1 Tone (Wet, Plate, Hall, Spring, Shimmer, Detune) Echo Time Hold Time (Sustain) Effect Dependent Control 2 Pre-Delay (Wet, Plate) Modulation (Hall, Spring, Sustain) Reverb-to-effect Blend (Echo, Detune, Shimmer) Specifications Electrical Input level instrument / consumer line level Input impedance 1 MΩ Frequency response 20 Hz—30 kHz Total harmonic distortion < 0.01% *See User Guide for complete specifications. Power Input 9-12 V DC, 100 mA Connector center-negative, 5.5 mm OD x 2.1 mm ID Physical Dimensions 2.6” x 4.6” x 1.9” / 63 mm x 115 mm x 46 mm Weight 6.7 oz / 190 g *Specifications subject to change without notice. Resources User Guide Favorite Settings Sheet Pedal Comparison Reverb Is Better In Stereo Connect stereo outputs for a huge, immersive sounding reverb. Want to change it up and plug into a single amp? Immerse will sum a stereo input to mono with only output 1 connected. Low Power Consumption Use a standard 9 V or 12 V pedal power supply. Or, connect Immerse to a 100 mA output on a brick supply. Buffered Bypass It's great to have a buffer at the end of your signal chain. Analog Dry Signal Your dry signal remains analog for low noise and zero latency.