HappyModel SuperBee F4 Lite AIO Whoop Flight Controller - Choose Version
It's finally here! The ultralight 1s 5a AIO of the future comes in at a clean 2.8g. This is the AIO that got the mobula6 HDZero whoop under 25 grams. Be sure to check out all our Whoop FCs and our HappyModel gear collection! Due to this flight controller being a spare part for Mobula6 HDZERO, the original default device for OSD is “MSP” If you bought this flight controller and used it for an analog camera, you may need to change some settings. First, connect to Betaflight Configurator, then move to CLI command tab, and enter “set osd_displayport_device = MAX7456”, then reconnect Betaflight, and upload the osd font. Specifications Board size: 25 x 25 Power supply: 1S Built-in 5A(each) Blheli_S 4in1 ESC Dshot600 ready Built-in Betaflight OSD(SPI Control) Built-in 5V 1A BEC Built-in voltage detection MCU upgraded to EFM8BB21 Support BLHeliSuite programmable Factory firmware: S_H_50_REV16_8.HEX Default protocol: DSHOT150/DSHOT300/DSHOT600 FRSKY SPI BUS RECEIVER Frsky D8/D16 switchable Compatible Non-EU transmitter in both D8 and D16 mode Channels: 8ch or 16ch Failsafe support No ground interference (Transmitter and receiver 1 m from the ground): 300m ELRS SPI RECEIVER Packet Rate option: 25Hz/50Hz/150Hz/250Hz/500Hz RF Frequency: 2.4GHzAntenna plug: IPEX Telemetry output Power: <12dBm Receiver protocol: SPI ExpressLRS Could bind with ELRS V2.0 firmware TX module Includes 1x HappyModel SuperBee F4 Lite AIO Whoop Flight Controller 1x PH2.0 Pigtail 1x Hardware Set