Mimosa B24 Backhaul point-to-point 24 GHz, 1.5 Gbps capable, 33 dBi, 4x4:4 MIMO
Performance Max Throughput: Up to 1.5 Gbps IP aggregate UL/DL Max PHY rate: 1.7 Gbps PHY Low Latency: <1 ms Supported MAC: TDMA, TDMA-FD Radio MIMO and Modulation: 4x4:4 MIMO OFDM up to 256 QAM Bandwidth: Single or dual channel; 20/40/80 MHz channel width Channel Spacing: Single channel allows 5 MHz channel spacing; Dual channel allows separate, no-overlapping 5 MHz spacing increments Frequency Range: 24.00 - 24.25 GHz worldwide support; Operating range is 24.07 - 24.23 GHz EIRP: ~20 dBm (CE)~33 dBm (FCC/IC)~37 dBm (other regions) Min Output Power: -20 dBm Power Increment Level: 1 dB Sensitivity (MCS0): -84 dBm @ 80 MHz-87 dBm @ 40 MHz-90 dBm @ 20 MHz Antenna Gain: 33 dBi Beamwidth (3dB): 3.0º Elevation Adjust: +-2.5º azimuth mechanical adjust+-15º elevation mechanical adjust Front to Back Ratio: >30 dB Cross-Polar Isolation: >20 dB Polarization: Dual-linear (slant 45º) Power Max Power Consumption: 19.5 W System Power Method: 48V DC 802.3at compliant System Lightning & ESD Protection: 6 kV PoE Power Supply: Passive POE compliant, 50V 1.2A power over ethernet (included) Physical Dimensions: Height: 260 mm (10.24”)Width: 260 mm (10.24”)Depth: 134 mm (5.3”) without bracket; 252 mm (9.9”) with bracket Weight: 2.76 kg (6 lbs) including mount Enclosure Characteristics: Outdoor UV stabilized plastic;Powder-coated, aluminum mounting panel Wind Survivability: 200 km/h (125 mph) Wind Loading: 12.52 kg @ 160 km/h(27.61 lbs @ 100 mph) Mounting: Precision lightweight aiming pole mount with +-15º elevation and +-2.5º horizontal adjustment screws Network Interfaces: Gigabit ethernet(RJ45) and gigabit fiber (SFP cage); Operation modes: Hot standby Environmental Outdoor Ingress Protection Rating: IP67 Operating Temperature: -40°C to +55°C (-40°F to 131°F) Operating Humidity: 5 to 100% condensing Operating Altitude: 4,420 m (14,500’) max Shock & Vibration: ETS 300-019-2-4 class 4M5 Regulatory and Compliance Approvals: FCC 15.249IC RSS210ETSI EN 300-440 V2.1.1CE RoHS Compliance: Yes; WEEE Safety: EC/EN/ 60950-1 Features Gigabit Ethernet: 10/100/1000-BASE-T Fiber Capable: Supports SFP interface for fiber operation Ethernet Redundancy: Dual Link failover; Does not support simultaneous ethernet + fiber operation Dual Protocol Operation: 2 dual-stream radios operating on non-contiguous frequencies allow for traditional FDD-like performance or TDMA automatic load balancing of traffic across 4 total MIMO streams with individual stream encoding up to 256 QAM Management Services: Mimosa cloud monitoring and managementSNMPv2 & Syslog monitoring HTTPSHTML5 based web UI2.4 GHz 802.11b/g/n radio for local management access Smart Antenna Alignment: Hands-free, dedicated 2.4 GHz WiFi management radio Smart Spectrum Management: Active scan monitors/logs ongoing RF interference across channels with no service impact; Dynamic auto-optimization of bandwidth, power, and modulation Security: 128-bit AES PSK with hardware acceleration QoS: Supports 4 pre-configured QoS levels GPS Location: GNSS-1 (GPS + GLONASS) Collocation Synchronization: 1PPS GPS TX/RX synchronization for collocated co-channel radios; Adjustable up/downstream bandwidth ratio