BETAFPV F4 2S Brushless Whoop Flight Controller and ESC (XT-30)

Equipped with an amazing F405 on this tiny stack, you will be flying like you are using your mini quad. Features like OSD, available RSSI ports, buzzer pads, and options for TBS receivers gives this stack tons of options! This F4 flight controller and ESC have been customized for the Beta65X and Beta75X brushless whoop drones from BETAFPV. Equipped with an amazing F405 on this tiny stack, you will be flying like you are using your mini quad. Features like OSD, available RSSI ports, buzzer pads, and options for TBS receivers gives this stack tons of options!  Note that even though the form factor is the same as other whoop stacks, the motor connectors on the ESC have 3 pins for use of brushless motors, so it won't work with brushed builds.  This version of the board comes with an XT-30 connector soldered on. Specifications F4 Flight Controller CPU: STM32F405 (Overclock to 240MHz) Six-Axis: MPU6000 Size: 26mm x 26mm, whoop mounting pattern Firmware version: Betaflight OMNIBUSF4SD (OBSD) OSD: Built-in BetaFlight OSD (STM32 controls OSD chip over SPI in DMA mode) TX02、RX02 ports are available so that it could support TBS micro receiver RSSI ports are available Buzzer solder pads Weight: 2.7g ESC Support BLheli/BLHELI_S suite Pass-through ready Support PPM, Oneshot125, Oneshot42, Multishot, Dshot150, Dshot300, Dshot600 Input voltage: 2S Lipo Continuous current: 6A Peak current: 10A  Firmware: BLHELI_S Processor: SILABS EFM8BB21F16G Motor Connectors: 1.5mm header pins connector Compatible Receivers All the ports are available on this board. So that you could connect any receiver you want on the board. For example. Frsky XM/XM+ Receiver TBS receiver DSMX receiver For the details about how to connect the receiver and configure in Betaflight, please check the F4 2S Brushless FC & ESC Manual. Includes 1x F4 2S brushless flight controller 1x 4in1 6A ESC board (XT-30) 4x M1.2x4mm screws 4x M1.4x5mm screws 1x 5-pin header 4x Anti-vibration rubber dampers