Solo2Go 1-Port Wi-Fi Pixel Controller

1-Port Pixel Controller (upgradable to 8-Port w/ the Differential Module) Revision 1.0 Wi-Fi support (2.4GHz only) ESP32 Based Expansion header (Ethernet, Differential, SD Card, 4-Button, IR Receiver and Audio-Reactive Modules available, sold separately) WLED 0.15.0 pre-installed XLights Compatible 5V Data Signal, 33 ohms Modular and repairable Supports 24v, 12v & 5v pixels and strip (3 pin only, no CLK) Runs WLED software, pre-installed Dimensions: 33mm x 98mm (roughly 1.5" x 4") 5A MAX per output. (5A Total)(Over 200 LEDs per output should only exceeded only with proper voltage injection or reduced brightness) NOTE - Due to size constraints,. there is NO REVERSE POLARITY PROTECTION on the Solo2Go - Always double-check your power wiring!!! Reversed polarity will damage your controller and your lights. How many pixels can it support?The ESP32 can calculate about 65k-85k LEDs per second (that means 1000 LEDs @~70fps, 2000 LEDs @~35fps, 4000 LEDs @~18fps)* For excellent performance, it is recommended to use 400 pixels/output  (RECOMMENDED)*For very good performance, it is recommended to use 600pixels/output*For good performance, you can use 800 pixels/output *For okay performance, you can use 1000 pixels/output OutputPort1: GPIO2