DFRobot Gravity: Analog Signal Isolator

Description DFRobot Gravity: Analog Signal Isolator Efficient in preventing the electrical interference between sensors Operating Voltage: 5.0V Response Time: 4 seconds (Typ) The DFRobot Gravity: Analog Signal Isolator has an onboard 5V isolation power which could directly supply to the sensor. Therefore, you do not need to prepare the external power, such an easy and practical! The connector of wires are special designed for DFRobot 3Pin analog sensor, plug and play, no need for soldering. The analog signal transmission ratio is 1:1, which contributes to a very small impact on output signals of sensors when this module connect into the circuit. Furthermore, you do not need to change the code of the mainboard. This analog signal isolator is applicable to prevent interferences between sensors, such as a multi-parameter water quality monitoring system that need to prevent interferences between water sensors. View more What's Included 1x DFRobot Gravity: Analog Signal Isolator 2x PH2.0-3P Cable Dimensions 42 x 32 mm / 1.65 x 1.26 inch Links Website Gravity: Analog Signal Isolator - Wiki PDF File Gravity: Analog Signal Isolator - Schematic Specifications Operating Voltage: 5.0V Response Time: 4 seconds (Typ) Analog Error between Two Terminals: <± 20mV (Typ) Conector Type: PH2.0-3P No-load Current: 75 mA Non-isolation Terminal (MCU Terminal)                 Supply Voltage: 5.0 ± 0.1V                 Analog Output: 0 ~ 5.0V Isolation Terminal (SEN Terminal)                 Output Voltage: 5.0 ± 0.2V                 Analog Input: 0 ~ 5.0V