End Game Flipper Zero™ WiFI GPIO Module

Take your Flipper's™ WiFi hacking capabilities to the absolute next level! A true 3-in-1 module, End Game includes a ESP32-S3 and two optional module slots. Instantly swap between the ESP32-S3 and two modules using the slide switch. This configuration has a CC1101 module or a NRF24 module. End Game comes flashed with the manufacturer's personal fork of wifi marauder that includes a few "quality of life" changes. Some specifics about the End Game device: Features Slide toggle switch to instantly swap between modules (left position - left module, center position - ESP32-S3, right position - right module). LED status indicators displaying active module selection. ESP32-S3 RGB status indicator (used for attack/sniffing status in wifi marauder - GPIO16). ESP32-S3 RX/TX LED indicators. ESP32-S3 boot & restart buttons (used for flashing & restart ESP32-S3). ESP32-S3 micro-SD card reader (used saving PCAP's of sniffed traffic in wifi marauder). ESP32-S3 will come pre-flashed with Wifi Marauder, ready to start sniffing traffic from the get go.. (pssst if you see the RGB rainbow you've sniffed a EAPOL packet, nice!). Supports flashing the ESP32-S3 directly from the flipper zero using USB-UART bridge. Compatible with the Wifi Marauder companion flipper app, allowing you to control the ESP32-S3 directly from the Flipper Zero. External antennas are cross-compatible with modules for general use, optionally you could use more fine tuned antennas for increased performance. Compatible with flipper zero silicone cases. Module pin-out Row 1 Row 2 1: GND 2: 3V3 3: B2 4: A4 5: B3 6: A7 7: A6 8: N/C     NOTE:  Flipper™ the Flipper Dolphin logo and Flipper Zero™ are trademarks owned by Flipper Devices, Inc.