4"HDMI LCD IPS Display 800x480 Resistive Touch Screen for Raspberry Pi
Description： 4.0-inch IPS full-angle display, support HDMI input, refresh rate up to 60FPS The physical resolution is 800x480 Raspberry Pi monitor with touch control (need to install touch driver) It can be used as standard HDMI output device for computer display(no touch function) Compatible with and can be directly inserted into all versions of raspberry PI motherboards (raspberry PI 1 generation B and Zero need additional HDMI cable) Support HDMI audio output, backlight brightness adjustable Specification: Screen Siz: 4.0inch Model No: ZO MPI4008 LCD Type: TFT Module Interface:HDMI Resolution:800*480 (Pixel) Active Area:51.84x86.40(mm) Touch Screen Controller:XPT2046 LCD Driver IC:NT35510 Backlight:LED power consumption :0.16A*5V Working temperature（℃）:-20~60 Module PCB Size: 98.60*58.05 (mm) Package Size: 143*134*51 (mm) Rough Weight(Package containing) (g):126 (g) Dimensions Hardware Description ① 3.5mm Headphone Jack: Output audio signal② HDMI：Used to connect the main board and LCD display for HDMI transmission③ Micro USB：Get 5V Power from USB, If ⑤-13*2 Pin Socket has been connected, that this USB interface can be No Connect.④ Backlight adjustment button: Short press backlight change 10%, long press a few seconds to close backlight; short press to open backlight⑤ 13*2 Pin Socket：Get +5V Power from raspberry Pi to LCD, at the same time transfer touch signal back to Raspberry Pi. 13*2 Pin Socket interface definition: Pin Name Description 1、17 3.3V Power supply +3.3V 2、4 5V Power supply +5V 3、5、7、8、10、11、12、13、15、16、18、24 NC NC 6、9、14、20、25 GND GND 19 TP_SI SPI data input of touch panel 21 TP_SO SPI data output of touch panel 22 TP_IRQ The touch panel is interrupted and the low level is detected when the touch panel is pressed down 23 TP_SCK Touch the SPI clock signal of the panel 26 TP_CS Touch panel select signal, low level select touch panel How to use as PC Monitor Connected the computer HDMI output to the LCD HDMI interface by HDMI cable. Power to Micro USB interface If you have multiple monitors, please pull the other displayer, and make this LCD as the only displayer for testing. As computer monitors, the touch function will not be available.